User Manual

Calibrating Output Power
68P09255A57-2
Aug 2002
SC4812ET Optimization/ATP Manual Software Release R16.1.x.x
PRELIMINARY
G-12
NOTE
Do not download code or data to any cards other than those you
are working on. Downloading code or data to other cards will
take the site OUT OF SERVICE.
The code file version numbers must match the version numbers
on the other cards in the frame. If the numbers do not match, the
site may go OUT OF SERVICE.
The BTS-#.cdf, CBSC-#.cdf, and CAL files for this BTS must
have come from the CBSC.
 Test equipment has been configured per Figure G-9 or Figure G-10.
 An RFDS (or at a minimum a directional coupler), whose loss is
already known, must be in line to perform the in-service calibration.
 Test equipment has been calibrated after 1 hour warm up.
 A short RF cable and two BNC-N adapters are available to perform
Cable Calibration.
 The Power Delta Calibration has been performed (see Table G-1,
Table G-2, or Table G-3).
G