User Manual

Initializing Active Service68P09255A57-2

Aug 2002

SC4812ET Optimization/ATP Manual Software Release R16.1.x.x

PRELIMINARY

5-5

Figure 5-1: MGLI3/SGLI3 MMI Port Connection

REF- FW00344

9-PIN TO 9- PIN

RS-232 CABLE

NULL MODEM BOARD

(PART# 8484877P01)

RS-232 CABLE

FROM LMF COM1

PORT

MMI SERIAL PORT

GLI BOARD

Set BTS Site Span Configuration

Perform the procedure in Table 5-5 to configure the Span Framing

Format and Line Build Out (LBO) parameters. ALL MGLI3/SGLI3

boards in all C-CCP shelves that terminate a T1/E1 span must be

configured.

NOTE

Perform the following procedure ONLY if span configurations

loaded in the MGLI3/GLI3s do not match those in the

OMCR/CBSC data base, AND ONLY when the exact

configuration data is available. Loading incorrect span

configuration data will render the site inoperable.

Table 5-5: Set BTS Span Parameter Configuration

Step Action

1 If not already done, connect a serial cable from the LMF COM1 port (via null modem board) to the

front panel of the MGLI3 MMI port (see Figure 5-1).

2 Start an MMI communication session with CSM-1 by using the Windows desktop shortcut icon (see

Table 3-5 on page 3-17).

NOTE

The LMF program must not be running when a Hyperterminal session is started if COM1 is being

used for the MMI session.

. . . continued on next page