User Manual

ATP Tests
68P09255A57-2
Aug 2002
SC4812ET Optimization/ATP Manual Software Release R16.1.x.x
PRELIMINARY
4-8
Background: Rho Test
This test verifies the transmitted Pilot channel element digital waveform
quality of each BBX2 carrier keyed up at a specific frequency per the
current CDF file assignment. All tests are performed using the external
calibrated test set controlled by the same command. All measurements
are via the appropriate TX OUT (BTS/RFDS) connector.
The Pilot Gain is set to 262 for each antenna, and all channel elements
from the MCCs will be forward link disabled. The BBX2 is keyed up
using both bbxlvl and bay level offsets, to generate a CDMA carrier
(with pilot channel element only, Walsh code 0). BBX2 power output is
set to 40 dBm as measured at the TX OUT connector (on either the BTS
or RFDS directional coupler).
The calibrated communications test set measures and returns the Pilot
channel element digital waveform quality (rho) in dB, verifying that
result meets system tolerances. Waveform quality (rho) should be
>
0.912 (-0.4 dB).
The BBX2 then de-keys and the applicable redundant BBX2 is assigned
to the current TX antenna path under test. The test is then repeated.
The LMF Tests menu list item, Rho, performs the waveform quality test
for a XCVR(s). All measurements are made through the appropriate TX
output connector using the calibrated TX cable setup.
Background: Pilot Offset Acceptance Test
This test verifies the transmitted Pilot channel element Pilot Time Offset
of each BBX2 carrier keyed up at a specific frequency per the current
CDF file assignment. All tests are performed using the external
calibrated test set controlled by the same command. All measurements
will be via the appropriate TX OUT (BTS/RFDS) connector.
The Pilot Gain is set to 262 for each antenna and all TCH elements from
the MCCs are forward link disabled. The BBX is keyed up using both
bbxlvl and bay level offsets to generate a CDMA carrier (with pilot
channel element only, Walsh code 0). BBX power output is set to
40 dBm as measured at the TX OUT connector (on either the BTS or
RFDS directional coupler).
The calibrated communications test set measures and returns the Pilot
Time Offset in uS, verifying results meet system tolerances. Pilot Time
Offset should be within <
3 µs of the target PT Offset (0 mS).
The BBX2 then de-keys, and the applicable redundant BBX2 is assigned
to the current TX antenna path under test. The test is then repeated.
4