User Manual
Adjusting for loss
68P09255A57-2
Aug 2002
SC4812ET Optimization/ATP Manual Software Release R16.1.x.x
PRELIMINARY
3-86
WARNING
Editing the CAL file is not encouraged as this action can cause
interface problems between the BTS and the LMF. To manually
edit the CAL file you must first logout of the BTS. If you
manually edit the CAL file and then use the Create Cal File
function the edited information will be lost.
Prerequisites
Before running this test, the following should be done:
LMF is logged in to the BTS
BBXs are OOS_RAM with BLO downloaded
Table 3-45: Create CAL File
Step Action
1 Select the applicable BBXs. The CAL file will only be updated for the selected BBXs.
2 Click on the Device menu.
3 Click on the Create Cal File menu item.
The status report window is displays the results of the action.
4 Click OK.
RFDS Description
The optional RFDS is used to perform RF tests of the site from the
CBSC or from the LMF. The RFDS contains the following FRUs:
Antenna Select Unit (ASU)
Fixed Wireless Terminal Interface Card (FWTIC)
Subscriber Unit Assembly (SUA)
For complete information regarding the RFDS, refer to the CDMA, and
the.LMF Help function on-line documentation.
RFDS Parameters
The bts-#.cdf file includes RFDS parameter settings that must match the
installed RFDS equipment. The paragraphs below describe the editable
parameters and their defaults. Table 3-46 explains how to edit the
parameter settings.
RfdsEquip - valid inputs are 0 through 2.
0 = (default) RFDS is not equipped
1 = Non-Cobra/Patzer box RFDS
2 = Cobra RFDS
TsuEquip - valid inputs are 0 or 1
0 = (default) TSU not equipped
1 = TSU is equipped in the system
MC1....4 - valid inputs are 0 or 1
0 = (default) Not equipped
1 = Multicouplers equipped in RFDS system
(SC9600 internal RFDS only)
3