User Manual

Adjusting for loss

68P09255A57-2

Aug 2002

SC4812ET Optimization/ATP Manual Software Release R16.1.x.x

PRELIMINARY

3-84

Exception Handling

In the event of a failure, the calibration procedure displays a FAIL

message in the status report window and provides information in the

Description field.

Recheck the test setup and connection and re-run the test. If the tests fail

again, note specifics about the failure, and refer to Chapter 6,

Troubleshooting.

All Cal/Audit Test

The Tests menu item, All Cal/Audit, performs the TX BLO Calibration

and Audit test for a XCVR(s). All measurements are made through the

appropriate TX output connector using the calibrated TX cable setup.

NOTE

If the TX calibration portion of the test passed, the BLO data

will automatically be downloaded to the BBX(s) before the audit

portion of the test is run.

Prerequisites

Before running this test, the following should be done:

 CSM-1, GLI3s, BBXs have correct code and data load.

 Primary CSM and MGLI3 are INS.

 All BBXs are OOS_RAM.

 Test equipment and test cables are calibrated and connected for TX

BLO calibration.

 LMF is logged into the BTS.

Follow the procedures in Table 3-44 to perform the All Cal/Audit test.

WARNING

Before installing any test equipment directly to any TX OUT

connector, first verify there are no CDMA BBX channels

keyed. Failure to do so can result in serious personal injury

and/or equipment damage.