User Manual

System Tests
68P09255A57-2
Aug 2002
SC4812ET Optimization/ATP Manual Software Release R16.1.x.x
PRELIMINARY
3-42
Table 3-25: Test Equipment Setup (GPS & LFR/HSO Verification)
Step Action
3 Reinstall CSM-2.
4 Start an MMI communication session with CSM-1 by using the Windows desktop shortcut icon (see
Table 3-5)
NOTE
The LMF program must be running when a Hyperterminal session is started.
5 When the terminal screen appears press the Enter key until the CSM> prompt appears.
CAUTION
Connect GPS antenna to the (GPS) RF connector ONLY. Dam-
age to the GPS antenna and/or receiver can result if the GPS an-
tenna is inadvertently connected to any other RF connector.
Figure 3-7: CSM MMI Terminal Connection
NULL MODEM
BOARD
(TRN9666A)
RS-232 SERIAL
MODEM CABLE
DB9-TO-DB25
ADAPTER
COM1
LMF
NOTEBOOK
FW00372
CSM board shown
removed from frame
19.6 MHZ TEST
POINT REFERENCE
EVEN SECOND
TICK TEST POINT
REFERENCE
GPS RECEIVER
ANTENNA INPUT
GPS RECEIVER
MMI SERIAL
PORT
ANTENNA COAX
CABLE
REFERENCE
OSCILLATOR
9-PIN TO 9-PIN
RS-232 CABLE
NOTES:
1. One LED on each CSM:
Green = IN-SERVICE ACTIVE
Fast Flashing Green = OOS-RAM
Red = Fault Condition
Flashing Green & Red = Fault
LED (NOTE 1)
3