User's Manual Part 1

Unpacking the Equipment – continued
Jun 2004
2-13
1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU
DRAFT
Removing Indoor Equipment
from a Container
Follow the procedure in Table 2-5 to remove the indoor equipment from
a container. The following procedure starts with the BTS removal and
continues through to the Mounting Plate. The order of opening
containers is not important, it is just for demonstration purposes. The
procedure is written for one set. Perform procedure as many times as
required to accommodate the site configuration.
Table 2-5: Procedure to Remove Indoor Equipment from Container
Step Action
1 Inspect containers for damage. Use tin snips or knife to cut straps holding Mounting Plate container to
the BTS container.
2 Open container holding Mounting Plate and accessories.
3 Remove Mounting Plate and accessories and place on a flat surface.
4 Open shipping container holding BTS.
5 Remove box containing RGPS or Local GPS (RF–GPS) antenna and cabling, and place on a flat
surface.
6 Remove insert.
7 Remove packing surrounding BTS.
8 Remove BTS and place on a flat surface.
NOTE
If a cCLPA has also been shipped, proceed to step 9; otherwise, proceed to step 12.
9 Open shipping container holding cCLPA. Perform Table 2-3.
10 Remove packing surrounding cCLPA.
! CAUTION
Be careful not to damage the cooling fins on the cCLPA.
11 Remove cCLPA and place on a flat surface.
12 Take inventory of equipment received. Report the extent of any equipment damage to the transport
company and to appropriate management personnel.
2