User's Manual Part 1

Unpacking the Equipment – continued
DRAFT
1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU
Jun 2004
2-12
Table 2-4: Procedure to Remove Outdoor Equipment from Container
Step Action
n WARNING
The TME and HMS are shipped as one unit. Together they weigh 39 kg (86 lbs). It is recommended
that the HMS be removed first; otherwise, two people are required to remove the TME with HMS
installed.
6 Use the key to unlock the HMS and open.
7 Use a wrench to remove two nuts and washers securing ground cable to HMS.
8 Disconnect signal cable from TME.
9 Remove HMS from TME hinges and place on a flat surface.
10 Remove TME and place on its backside on a flat surface.
11 Open shipping container holding PDE. Perform Table 2-3.
12 Remove box containing the Wall Mounting Bracket from insert.
13 Remove insert.
n WARNING
The PDE and HX are shipped as one unit. Together they weigh 52 kg (115 lbs). It is recommended
that a minimum of two people be required to remove the PDE with HX installed.
13a Remove PDE and place on its backside on a flat surface.
14 Open shipping container holding cCLPA. Perform Table 2-3.
! CAUTION
Be careful not to damage the cooling fins on the cCLPA.
14a Remove cCLPA and place on its backside on a flat surface.
15 Remove associated accessories and place on a flat surface.
16 Open shipping container holding BTS. Perform Table 2-3.
17 Remove box containing RGPS or Local GPS (RF–GPS) antenna and cabling, and place on a flat
surface.
NOTE
RGPS or RF–GPS may have been shipped in a separate container.
18 Remove packing surrounding BTS.
19 Remove BTS and place on a flat surface.
20 If system is to be pole mounted proceed to step 21; otherwise, proceed to step 23.
21 Open shipping container holding Pole Mounting Assembly.
22 Remove Pole Mounting Bracket Assembly from container and set on a flat surface.
23 Take inventory of equipment received. Report the extent of any equipment damage to the transport
company and to appropriate management personnel.
2