User's Manual Part 1

ATP Tools and Materials – continued

Jun 2004

1-19

1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU

DRAFT

Directional Coupler

S 30 dB attenuation

Optional Equipment

Not all optional equipment specified here will be supported

by the LMF in automated tests or when executing various

measure type commands. It is meant to serve as a list of

additional equipment that might be required during

maintenance and troubleshooting operations.

NOTE

Digital Multimeter

S Fluke Model 8062A with Y8134 test lead kit or equivalent; used for

precision dc and ac measurements, requiring 4–

digits.

Frequency Counter

S Stanford Research Systems SR620 or equivalent. If direct

measurement of the 3 MHz or 19.6608 MHz references are required.

Spectrum Analyzer

S Spectrum Analyzer (HP8594E with CDMA personality card) or

equivalent; required for manual tests other than standard Receive

band spectral purity and TX cCLPA IM reduction verification tests

performed by the LMF.

LAN Tester

S Model NETcat 800 LAN troubleshooter (or equivalent); Used to

supplement LAN tests using the ohm meter.

Span Line (T1 or E1) Verification Equipment

S As required for local application

RF Test Cable (if not provided with test equipment)

S Motorola Model TKN8231A; used to connect test equipment to the

BTS transmitter output during optimization procedures.

Oscilloscope

S Tektronics Model 2445 or equivalent; used for waveform viewing,

timing, and measurements procedures.

CDMA Subscriber Mobile or Portable Radiotelephone

S CDMA compatible with power supply and antenna; used to provide

test transmission and reception during BTS maintenance. Two radios

will be required for system and drive around testing after optimization

and BTS ATP is completed.