User's Manual Part 1

ATP Tools and Materials – continued
Jun 2004
1-15
1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU
DRAFT
Test Equipment List
The following pieces of test equipment are required during the ATP.
Common assorted tools like screwdrivers and keys are not listed, but are
still required. Read the owners manual on all of the following major
pieces of test equipment to understand their individual operation prior to
use in optimization.
Always refer to specific OEM test equipment
documentation for detailed operating instructions.
NOTE
CDMA LMF Hardware Requirements
A CDMA LMF computer platform that meets the following
requirements (or better) is recommended:
S Notebook computer
S PCMCIA to Serial I/O Adapter
S 266 MHz (32 bit CPU) Pentium processor
S 4 GigaByte internal hard disk drive
S SVGA 12.1 inch active matrix color display with 1024 x 768
(recommended) or 800 x 600 pixel resolution and capability to display
more than 256 colors
S 128 MB RAM minimum (98SE) or 256 (Windows 2000)
S 20X CD ROM drive
S 3–1/2 inch floppy drive
S Serial port (COM 1)
S Serial Port (COM 2)
S Parallel port (LPT 1)
S PCMCIA Ethernet interface card (for example, 3COM Etherlink III)
with a 10Base–T–to–coax adapter
S Windows 98 SE or higher operating system
If 800 x 600 pixel resolution is used, the CDMA LMF
window must be maximized after it is displayed.
NOTE
Ethernet LAN Transceiver (part of all LMF kits)
S PCMCIA Ethernet Adapter + Ethernet UTP Adapter 3COM Model –
Etherlink III 3C589B
used with
S Transition Engineering Model E–CX–TBT–03 10BaseT/10Base 2
Converter
1