User's Manual Part 1

Compact BTS and HMS Installation – continued
Jun 2004
4-31
1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU
DRAFT
Table 4-17: Procedure to Install the HMS
Step Action
2 Set the HMS on the hinges located on the TME (See Figure 4-21).
3 Use a driver wrench with socket to attach ground lug to HMS ground connection.
4 Connect the Data/DC PowerCable to HMS controller.
5 Dress cables as necessary.
6 Ensure that door swings freely and does not pinch any cables.
7 Close HMS and secure using the two draw latches. Fold draw latch handles down. Verify that HMS is
fully closed and seated.
8 Close draw latch door and lock using key.
Figure 4-21: HMS Installation
ti–cdma–wp–00320–v02–ildoc–ah
Set HMS on TME hinges.
HMS
TME
4