User's Manual Part 1

ManualsBrandsNokia Solutions and Networks ManualsElectronics1X-EVDO SC480 BTS Microcell Base Station Transmtr

131

132

133

134

135

136

137

138

139

140

Thermal Management Enclosure Installation – continued

DRAFT

1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU

Jun 2004

4-24

Table 4-14: Procedure to Pole Mount the TME

Step Action

1 Slide non–buckle end of strap through openings in Pole Mounting Bracket Assembly.

2 Set Pole Mounting Bracket Assembly with straps at the desired height.

NOTE

Initial height is determined by customer. The bottom of the TME is a minimum of 1 meter from the

ground. Adjust Pole Mounting Bracket Assembly to account for this minimum distance.

3 Wrap strap around the pole, slide non–buckle end through strap loop and pull snug.

4 Attach Bucklestrap Cutting Tool (slide strap through openings in tool, pull gripper lever to slide strap

into spindle head), slide tool towards buckle. Place cutting tool end of tool as close to the buckle as

possible.

NOTE

The strap can be cut to a more manageable length prior to using the tool. Bucklestrap Cutting Tool is a

ratchet spindle and cutter in one.

5 Turn spindle clockwise until strap is tight.

6 Use cutter lever to cut strap.

7 Using the tool bend the strap over towards the buckle .

8 Remove tool and use a hammer to bend the strap more.

9 Use the hammer to bend buckle tabs over strap.

10 Use electrical tape to cover over the buckle and straps.

11 Perform step 3 through step 10, for the remaining straps.

12 Secure Wall Mounting Bracket to Pole Mounting Bracket Assembly using 8 M6 screws. Torque

screws to 3.4 N–M (30 in–lbs). See Figure 4-17.

n WARNING

The TME weighs 22 kg (48 lbs). One person is able to mount the TME on the Wall Mounting Bracket.

It is recommended that two people or one person using a mechanical lift to mount the TME onto

mounting bracket.

Do not place the Compact BTS inside the TME prior to placing it on the mounting bracket.

Remove the HMS prior to mounting the TME.

13 Set the TME onto the Wall Mounting Bracket. Ensure that it rests in the slots of the Wall Mounting

Bracket. See Figure 4-17.

14 Secure the TME to the mounting bracket using 6 M6 screws. Torque screws to 3.4 N–M (30 in–lbs).

See Figure 4-18.