User's Manual

Circuit BTS Shut Down Procedures – continued

Jun 2004 1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU 10-17

DRAFT

Table 10-4: Shut Down Carrier Signaling Functions Procedure For a Circuit BTS

n ActionStep

NOTE

The REDIRECT command is used to redirect subscribers to an 1.9 GHz site or to invoke the

REDIRECT2 command which is then used to redirect subscribers to a different CDMA carrier

frequency. REDIRECT2 is the preferred command if an alternate CDMA carrier is available.

* IMPORTANT

Record the values shown in the following system display response. These values are used to

answer the prompts for the EDIT CARRIER REDIRECT command when restoring signaling

operations at the end of the replacement procedure.

3 View the status of the carrier signaling REDIRECT parameters for an applicable carrier equipped

for a specific sector by entering the following command at the prompt:

omc–000000>DISPLAY CARRIER–<bts#>–<sector#>–<carrier#> REDIRECT

Observe the following typical system display response for carrier 1, sector 2 (this example shows

initial standard values):

Access Overload Class Redirect Flags ROTATE

CARRIER ID RETURN 0 0 0 0 0 0 0 0 0 0 1 1 1 1 1 1 TIMER RECORD EXP IGNORE SYS

(bts–sector–carrier) IF FAIL 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 (SEC) TYPE SID CDMA ORDERING

–––––––––––––––––––– ––––––– – – – – – – – – – – – – – – – – ––––– –––– ––– –––– –––––––

CARRIER–1–1–1 N N N N N N N N N N N N N N N N N 4 1 0 N CUSTOM

. . . continued on next page