User's Manual

Change GLI3 Span Parameter Settings – continued

Jun 2004 1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU G-11

DRAFT

Table G-3: Set GLI3 Span Parameter Configuration

Step Action

14 Once the card has completed resetting, execute the following command to verify span settings are as

required:

config ni current

A response similar to the following will be displayed :

The frame format in flash is set to use T1_2.

Equalization:

Span A – 0–131 feet

Span B – 0–131 feet

Span C – Default (0–131 feet for T1/J1, 120 Ohm for E1)

Span D – Default (0–131 feet for T1/J1, 120 Ohm for E1)

Span E – Default (0–131 feet for T1/J1, 120 Ohm for E1)

Span F – Default (0–131 feet for T1/J1, 120 Ohm for E1)

Linkspeed: 64K

Currently, the link is running at 64K

The actual rate is 0

15 If the span configuration is not correct, perform the applicable step from this table to change it and

repeat steps 12, 13, and 14 to verify required changes have been programmed.

16 If no other MMI actions are required for the card, terminate the MMI communication session and

disconnect the LMF computer from the card.