User's Manual

Change GLI3 Span Parameter Settings – continued

Jun 2004 1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU G-9

DRAFT

Table G-3: Set GLI3 Span Parameter Configuration

Step Action

At the entry prompt (>), enter the designator from the list for the span to be changed as shown in the

following example:

> a

A response similar to the following will be displayed :

COMMAND SYNTAX: config ni equal a equal

Next available options:

LIST – equal : Span Equalization

0 : 0–131 feet (default for T1/J1)

1 : 132–262 feet

2 : 263–393 feet

3 : 394–524 feet

4 : 525–655 feet

5 : LONG HAUL

6 : 75 OHM

7 : 120 OHM (default for E1)

8 : T1 Long Haul mode. No Attenuation

9 : T1 Long Haul mode. 7.5 dB Attenuation

10 : T1 Long Haul mode. 15.0 dB Attenuation

11 : T1 Long Haul mode. 22.5 dB Attenuation

12 : E1 Long Haul mode.

! CAUTION

When selecting span equalization settings, comply with the following or the BTS may operate

erratically or unpredictably:

S For ALL BTS types, do not select any of the following settings if they are displayed:

– 5 LONG HAUL

– 6 75 OHM

– 11 T1 Long Haul mode. 22.5 dB Attenuation

– 12 E1 Long Haul mode

S For four–digit BTSs supported with Channel Service Units (CSU), do not select any of the

following additional settings:

– 8 T1 Long Haul mode. No Attenuation

– 9 T1 Long Haul mode. 7.5 dB Attenuation

– 10 T1 Long Haul mode. 15.0 dB Attenuation

. . . continued on next page