User's Manual

Verify GLI3 Software Version and Span Parameter Settings – continued

Jun 2004 1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU G-5

DRAFT

Table G-2: Verify GLI3 Software Version and Span Parameter Settings

Step Action

Verify the span parameter settings for frame format, equalization, and linkspeed by entering the

following at the

GLI3> prompt:

config ni current

The system will respond with a display similar to the following:

The frame format in flash is set to use T1_2.

Equalization:

Span A – Default (0–131 feet for T1/J1, 120 Ohm for E1)

Span B – Default (0–131 feet for T1/J1, 120 Ohm for E1)

Span C – Default (0–131 feet for T1/J1, 120 Ohm for E1)

Span D – Default (0–131 feet for T1/J1, 120 Ohm for E1)

Span E – Default (0–131 feet for T1/J1, 120 Ohm for E1)

Span F – Default (0–131 feet for T1/J1, 120 Ohm for E1)

Linkspeed: Default (56K for T1 D4 AMI, 64K otherwise)

Currently, the link is running at the default rate

The actual rate is 0

NOTE

S Defaults for span equalization are 0–131 feet for T1/J1 spans and 120 Ohm for E1.

S Default linkspeed is 56K for T1 D4 AMI spans and 64K for all other types.

S There is no need to change from defaults unless the provisioned span configuration requires it.

6 The span parameter settings in the GLI must match those provisioned in the OMC–R database for the

BTS. If they do not, proceed to Table G-3 in the Change GLI3 Span Parameter Settings section.

7 If no other MMI actions are required for the card, terminate the MMI communication session and

disconnect the LMF computer from the card.