User's Manual

Verify GLI3 Software Version and Span Parameter Settings – continued

Jun 2004 1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU G-3

DRAFT

Table G-2: Verify GLI3 Software Version and Span Parameter Settings

Step Action

1 If it has not been done, start a GLI3 MMI communication session on the LMF computer as described

in Table 6-11.

2 Verify the installed software version by entering the following at the GLI3 prompt:

display version

3 Response to the command will depend on the operating mode of the card. Responses similar to the

following will be displayed for:

3a – Cards in circuit mode:

GLI3> display version

01.09.1980 20:01:59 MGLI–002–2 OOS–SBY BTS–CDMA 16.41.200.14

RAM version: 16.41.200.14

ROM version: 16.41.200.14

Built: Tue Oct 21 09:52:28 2003 il27–2112

Bootrom version: 16.41.200.12

Bootrom Built: Thu Oct 2 03:11:34 2003 IL27–0775

Bootblock version: 16.1.59.00

Bootblock Built: Wed Apr 10 07:08:06 2002 RIPCORD004

This GLI board is in RAM

Booted from /nvram00/loads/gli3_ckt_rom_upgrade.elf

Next boot from /nvram00/loads/gli3_ckt_rom_upgrade.elf

GLI3>

. . . continued on next page