User's Manual

Verifying and Setting GPIB Addresses – continued

Jun 2004 1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU B-11

DRAFT

Hewlett Packard HP8921A and

HP83236A/B GPIB Address

Refer to Figure B-8 and follow the procedure in Table B-8 to verify and,

if necessary, change the HP 8921A HP 83236A GPIB addresses.

Figure B-8: HP 8921A and HP 83236A/B

Preset

Cursor Control

Shift

Local

NOTE

This procedure assumes that the test equipment is set up and

ready for testing.

Table B-8: Verify and/or Change HP 8921A and HP 83236A GPIB Addresses

Step Action

To verify that the GPIB addresses are set correctly, press Shift and LOCAL on the HP 8921A.

– The current HP–IB address is displayed at the top of the screen.

NOTE

HP–IB is the same as GPIB.

2 If the current HP–IB address is not set to 18, perform the following to change it:

2a – Turn the Cursor Control knob to move the cursor to More and press the knob to select the field.

2b – Turn the Cursor Control knob to move the cursor to I/O Config and press the knob to select the

field.

2c – Turn the Cursor Control knob to move the cursor to Adrs and press the knob to select the field.

2d – Turn the Cursor Control knob to change the HP–IB address to 18 and press the knob to set the

address.