User's Manual

Verifying and Setting GPIB Addresses – continued

Jun 2004 1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU B-9

DRAFT

Advantest R3562 Signal

Generator GPIB Address

Set the GP–IB ADDRESS switch on the rear of the Advantest R3562

signal generator to address 1 as shown in Figure B-6.

Figure B-6: Advantest R3562 GPIB Address Switch Setting

1234567 8

54321

GP–IP ADDRESS

GPIB Address set to “1”

Agilent 8935 Series E6380

(formerly HP 8935) Test Set

GPIB Address

Refer to Figure B-7 and follow the procedure in Table B-7 to verify and,

if necessary, change the Agilent 8935 GPIB address.

Figure B-7: Agilent 8935 Test Set

Pre-

set

Cursor Control

Shift

Inst Con-

fig

Local

FW00885

NOTE

This procedure assumes that the test equipment is set up and

ready for testing.