User's Manual

Packet BTS Start–Up Procedures – continued

10-60 1X SC480 BTS Hardware Installation, Optimization/ATP, and FRU Jun 2004

DRAFT

Table 10-13: Restore Carrier Signaling Operations Procedure For a Packet BTS

n ActionStep

NOTE

In this step, you will change the value of the Global Service Redirection Flag

(GLOBALREDIRECT) in the congestion control parameters so that the Global Service Redirect

Message is only broadcast on the sector paging channel of a specific carrier when there is traffic

congestion in the carrier/sector.

7 Enter the following command at the prompt using one of the applicable carrier number and the

applicable sector number:

omc–000000>EDIT CARRIER–<bts#>–<sector#>–<carrier#> CONGESTCONF !

The system will prompt you to enter each control parameter value one at a time. Skip through the

prompts until you get to the following:

<globalredirect> , enter DISABLE

(This will revert the Global Service Redirect Message to congestion control.)

The system will display the values of the control parameters. Verify that only the

GLOBALREDIRECT value changed.

omc–000000>Accept [yes/no]?

Enter Y to accept the change.

Now the Global Service Redirection Message will only be sent over the sector paging channel

when there is traffic congestion in the carrier/sector.

8 Repeat step 7 for each remaining sector number disabled in step 14 of the shut down carrier

signaling functions procedure for a packet BTS Table 10-10.

9 Enter the following command at the prompt:

omc–000000>DISPLAY BTS–<bts#> CONGESTCONF

Observe the system display response.

Verify that the CONGESTCONF

globalredirect is disabled for the specific carrier on each the

applicable sectors.

10 View the status of the carrier signaling redirect parameters to verify the applicable carrier equipped

for the specific sector.

omc–000000>DISPLAY CARRIER–<bts#>–<sector#>–<carrier#> REDIRECT

Observe that the values in the system display response should match the values input in step 4 of

the shut down carrier signaling functions procedure for a packet BTS Table 10-10.

Access Overload Class Redirect Flags ROTATE

CARRIER ID RETURN 0 0 0 0 0 0 0 0 0 0 1 1 1 1 1 1 TIMER RECORD EXP IGNORE SYS

(bts–sector–carrier) IF FAIL 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 (SEC) TYPE SID CDMA ORDERING

–––––––––––––––––––– ––––––– – – – – – – – – – – – – – – – – ––––– –––– –––– ––– ––––––––

CARRIER–146–2–1 N Y Y Y Y Y Y Y Y Y Y Y Y Y Y Y Y 4 2 13 Y CUSTOM

. . . continued on next page