User's Manual

Prepare to Leave the Site

68P09258A31–A

Oct 2003

1X SCt 4812T BTS Optimization/ATP

5-8

Table 5-5: Set BTS Span Parameter Configuration

Step Action

5 This completes the site specific BTS Span setup for this GLI. Move the MMI cable to the next GLI2

and repeat steps 1 and 4 for ALL MGLI2/GLI2 boards.

6 Terminate the Hyperterm session and disconnect the LMF from the MGLI/SGLI.

LMF Removal

Perform the procedure in Table 5-6 as required to terminate the LMF

GUI session and remove the LMF computer.

Table 5-6: Terminate the LMF Session and Remove the LMF

Step Action

! CAUTION

DO NOT power down the CDMA LMF without performing the procedure indicated below.

Corrupted/lost data files may result, and in some cases, the CDMA LMF may lock up.

1 Log out of all BTS sessions and exit LMF by clicking on File in the LMF window menu bar and selecting

Logout and Exit from the pull–down list.

2 From the Windows Task Bar click Start>Shutdown. Click Yes when the Shut Down Windows

message appears.

3 Wait for the system to shut down and the screen to go blank.

4 Disconnect the LMF terminal Ethernet connector from the BTS cabinet.

5 Disconnect the LMF serial port, the RS-232 to GPIB interface box, and the GPIB cables as required

for equipment transport.