User's Manual

Automated Acceptance Test Procedures

68P09258A31–A

Oct 2003

1X SCt 4812T BTS Optimization/ATP

4-10

Table 4-1: ATP Test Procedure

Step Action

10 If applicable, select a test pattern from the Test Pattern pick list.

NOTE

S Selecting Pilot (default) performs tests using only a pilot signal.

S Selecting Standard performs tests using pilot, synch, paging and 6 traffic channels. This requires

an MCC to be selected.

S Selecting CDFPilot performs tests using only a pilot signal, however, the gain for the channel

elements is specified in the CDF file.

S Selecting CDF performs tests using pilot, synch, paging and 6 traffic channels, however, the gain

for the channel elements is specified in the CDF file.

11 Click on the OK button. The status report window and a Directions pop-up are displayed.

12 Follow the cable connection directions as they are displayed, and click the Continue button to begin

testing. The test results are displayed in the status report window.

13 Click on Save Results or Dismiss. If Dismiss is used, the test results will not be saved in the test

report file.