User's Manual

Preparation for Site Turn–over
68P09258A31–A
Oct 2003
1X SCt 4812T BTS Optimization/ATP
J-84
Preparation for Site Turn–over
Prepare the BTS site for turn–over to the control of the OMC–R by
performing the procedures in Table J-18 and Table J-19.
Table J-18: Prepare for Site Turn–over
Step Action
1 After disconnecting it from the BTS router, shut down the LMF computer.
2 If any additional external support equipment was used during the installation process, shut it down,
disconnect it from the frame.
3 Account for all tools used and parts removed from the frame during the installation, being sure none
were left inside the frame.
4 Visually inspect the frame for any foreign objects left inside, and remove any discovered.
5 Visually inspect all cable connections, ensuring they are connected as required for normal BTS
operation.
6 Be sure all internal frame cables are routed and secured to prevent damage to them when the frame
doors are closed.
7 Be sure all external frame and BTS router cables are routed and secured so they will not interfere with
normal maintenance and operational activities at the site.
8 Be sure the BTS routers are powered up and not reporting alarms other than span alarms.
Returning the Site to OMC–R Control
Follow the procedure in Table J-19 to return the site to OMC–R control.
Table J-19: Returning the Site to Operational Control
Step Action
1 Contact the OMC–R, and notify the operator the installation is complete. Request notification from
the operator when the routers have been downloaded with the full site–specific configurations and are
verified as functioning normally.
2 When notified router operation has been verified and the OMC–R can assume control of the site,
perform the following:
2a – On any frames which were opened, close and secure the cabinet doors.
2b – Verify no alarm conditions are being reported to the OMC–R with the frame doors closed.
2c – Prepare all equipment, tools, and parts removed from the frame for transport from the site.
What to Do Next
The installation of the Packet Backhaul option is complete. When the
site is secured, there are no further actions to perform at the BTS site.
J