User's Manual

Recovery From BTS Router Boot to rommon68P09258A31–A
Oct 2003
1X SCt 4812T BTS Optimization/ATP
J-69
Table J-15: Simple Recovery from BTS Router rommon Boot
Step Action
3 Note the IOS filename, and enter the following to begin recovery to an IOS boot:
boot slot0:IOS_filename
Where IOS_filename = the filename of the IOS noted in step 2, above.
A successful IOS re–boot operation will result in display of a response which begins and ends similar
to the following:
rommon 2 > boot slot0:mwr1941–i–mz.122–8.MC2a.bin
program load complete, entry point: 0x80008000, size: 0xb2a0
program load complete, entry point: 0x80008000, size: 0x6b99ac
Self decompressing the image :
################################################################### [OK]
Smart Init is enabled
smart init is sizing iomem
ID MEMORY_REQ TYPE
00031A 0X005F3C00 MWR1941 Mainboard
0X000F3BB0 public buffer pools
0X00211000 public particle pools
TOTAL: 0X008F87B0
.
.
.
Press RETURN to get started!
4 If the router successfully reboots with the IOS, proceed to step 7.
5 If the router does not reboot with the IOS, perform the following:
5a – Scroll the HyperTerminal display down until the directory display from step 2, above, is visible.
5b – Compare the IOS filename from the directory display with the filename entered in performing step
3, above.
5c – If the filename was typed incorrectly, repeat step 3, using care to type the filename correctly.
6 If the router does not reboot with the IOS after typing the filename correctly, proceed to Table J-16 and
perform the extended recovery procedure.
. . . continued on next page
J