User's Manual

Replacing Installed BTS Router CF Memory Card IOS Version
68P09258A31–A
Oct 2003
1X SCt 4812T BTS Optimization/ATP
J-48
Change CF Memory Card File Sequence to Place IOS File First on the Card
This procedure covers using an LMF computer equipped with a CF
memory card reader to perform the following activities:
1. Change the sequence of files on a CF memory card to place the IOS
version file first
2. Formatting the CF memory card, if necessary, to achieve the
required file sequence positioning of the IOS version file
Prerequisites
The following are required prior to performing this procedure:
S The LMF computer and BTS router have been prepared for CF
memory card reader file transfer and are operating as they would be
after performing the procedures in Table J-8 and steps 1 through 5 of
Table J-9
S Copies of the required IOS version and canned configuration files are
loaded into the desired directory of the LMF computer
Optional equipment/software
If they are available, the following items may be used to change the CF
memory card file sequence once the card is installed in the BTS router:
S Cable, Ethernet crossover, Category 5E or better, unshielded twisted
pair, two 8–contact modular plugs, in one of the following lengths, as
determined necessary:
– 0.3 m (11.8 in) (Motorola pn 3088643C07)
– 0.6 m (23.6 in)(Motorola pn 3088643C13)
– 1.0 m (39.4 in) (Motorola pn 3088643C15)
– 2.1 m (84 in) (Motorola pn 3088643C08)
– 3.0 m (120 in) (Motorola pn 3088643C09)
S A tftp server software application (refer to the Setting Up the TFTP
Server – Procedure in Cellular System Administration – CDMA
OnLine Documentation) such as:
– Cisco tftp server
– PumpKIN tftp server
– Any other equivalent tftp server application
Changing CF memory card file sequence
Follow the procedure in Table J-12 to place the installed IOS version file
first in the stored file sequence on the CF memory card.
J