User's Manual

Verifying IOS Canned Version of the CF Memory Card68P09258A31–A
Oct 2003
1X SCt 4812T BTS Optimization/ATP
J-33
Table J-8: Transfer Canned Configuration File to CF Memory Card with CF Memory Card Reader
Step Action
22 Remove the CF memory card with the IOS version and canned configuration file from the card reader,
and mark the card label with the canned configuration (blue or red) copied to it.
23 Install the CF memory card in the BTS router by following the procedure in the 1X SC 4812T BTS
FRU Guide .
24 Proceed to Table J-9 to copy the canned configuration from the CF memory card to the BTS router’s
startup–config file.
Copy Canned Configuration File from the CF Memory
Card to the BTS Router’s Startup Configuration and
verify IOS file sequence
To allow the BTS router to automatically boot using the canned
configuration, the configuration must be copied to the the router’s
startup–config file in NVRAM. Follow the procedure in Table J-9 to
accomplish this.
Table J-9: Copy Canned Configuration File to BTS Router Startup
Configuration and Verify IOS File Position
Step Action
* IMPORTANT
This procedure does not cover all aspects of BTS router operation and programming. Before performing this
procedure, review BTS router initialization, operation, and programming information and procedures in
MWR1941 Wireless Mobile Edge Router Software Configuration Guide; part number 78–13983–01. Have this
publication available for reference while performing this procedure.
1 If it has not been done, install the CF memory card with the canned configuration and required IOS
version in the BTS router by following the procedure in the 1X SC 4812T BTS FRU Guide .
2 At this point, the router should be powered up and displaying the Router> prompt in the
HyperTerminal window of the LMF computer communication session. If it is not, perform steps 1
through 6 of Table J-8.
3 At the Router> user EXEC mode prompt, enter the following to access the privileged EXEC mode:
enable
A response similar to the following will be displayed:
Router>enable
Router#
. . . continued on next page
J