User's Manual

Terminal Setup68P09258A31–A
Oct 2003
1X SCt 4812T BTS Optimization/ATP
J-5
Table J-1: Establish HyperTerminal Connection
Step Action
19
If desired, reposition the shortcut icon for the new connection by dragging it to another location on the
Windows desktop.
NOTE
The shortcut icon can now be double–clicked to open a BTS router or BTS card/module MMI
HyperTerminal session without the need to negotiate multiple menu levels.
BTS Router Serial Communication
For those procedures which require serial communication with BTS
routers, follow the procedures in Table J-2 to initiate the communication
session. This procedure calls out the LMF computer platform, but any
VT100–equivalent terminal or computer equipped with terminal
emulation software and a hardware serial connector may be used.
Required Items
The following items are required to perform the verification:
S LMF computer platform or equivalent (see this manual for
requirements)
S Eight–conductor (four–pair, unshielded twisted pair is acceptable)
rollover cable, two 8–contact modular plugs (see Figure J-1 for cable
wiring requirements)
S Adapter, DB–9 plug–to–8–contact modular plug, Global Computer
Supplies C4717 or equivalent (see Figure J-2 for adapter wiring
requirements)
Figure J-1: Wiring Diagram, BTS Router Communication Rollover Cable
8–contact Plug
Contact Numbering
(Insertion End)
12345678
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
8–contact
Modular
Plug
8–contact
Modular
Plug
Locking
Clip
J