User's Manual

Required Test Equipment and Software68P09258A31–A
Oct 2003
1X SCt 4812T BTS Optimization/ATP
1-7
Equipment Warm–up
After arriving at a site, test equipment should be plugged in and turned
on immediately to provide the longest possible time for warm up and
stabilization. The following pieces of test equipment must be
warmed–up for a minimum of 60 minutes prior to using for BTS
optimization or RFDS calibration procedures.
S Communications Test Set (Agilent E7495A requires only 30 minutes).
S Rubidium Time Base.
S Power Meter.
LMF computer and software
LMF Hardware Requirements
An LMF computer platform that meets the following requirements (or
better) is recommended:
S Notebook computer
S 266 MHz (32–bit CPU) Pentium processor
S MSr Windows 98R Second Edition (SE) or Windows 2000 operating
system
S 4 GB internal hard disk drive
S SVGA 12.1–inch active matrix color display with 1024 x 768
(recommended) or 800 x 600 pixel resolution and capability to display
more than 265 colors
NOTE
If 800 x 600 pixel resolution is used, the LMF window must be
maximized after it is displayed.
S Memory requirements:
– Minimum required RAM: 96 MB
– Recommended RAM:
–– 128 MB for Windows 98 SE
–– 256 MB for Windows 2000
S 20X CD ROM drive
S 3 1/2 inch floppy drive
S 56kbps V.90 modem
S Serial port (COM 1)
S Parallel port (LPT 1)
S PCMCIA Ethernet interface card (for example, 3COM Etherlink III)
with a 10Base–T–to–coax adapter
1