User's Manual

Test Equipment Set-up68P09258A31–A

Oct 2003

1X SCt 4812T BTS Optimization/ATP

3-57

Supported Test Equipment

CAUTION

To prevent damage to the test equipment, all TX test connections

must be through the directional coupler and in-line attenuator as

shown in the test setup illustrations.

IS–95 A/B Testing

Optimization and ATP testing for IS–95A/B may be performed using

one of the following test sets:

S CyberTest

S Advantest R3465 and HP 437B or Gigatronics Power Meter

S Hewlett–Packard HP 8935

S Hewlett–Packard HP 8921 (W/CDMA and PCS Interface for

1.7/1.9 GHz) and HP 437B or Gigatronics Power Meter

The equipment listed above cannot be used for CDMA 2000 testing.

CDMA2000 1X Operation

Optimization and ATP testing for CDMA2000 1X sites or carriers may

be performed using the following test equipment:

S Advantest R3267 Analyzer with Advantest R3562 Signal Generator

S Agilent E4406A with E4432B Signal Generator

S Agilent 8935 series E6380A communications test set (formerly HP

8935) with option 200 or R2K and with E4432B signal generator for

1X FER

The E4406A/E4432B pair, or the R3267/R3562 pair, should be

connected together using a GPIB cable. In addition, the R3562 and

R3267 should be connected with a serial cable from the Serial I/O to the

Serial I/O. This test equipment is capable of performing tests in both

IS–95 A/B mode and CDMA 2000 mode if the required options are

installed.

S Agilent E7495A communications test set

Optional test equipment

S Spectrum Analyzer (HP8594E) – can be used to perform cable

calibration.

Test Equipment Preparation

See Appendix F for specific steps to prepare each type of test set and

power meter to perform calibration and ATP.

Agilent E7495A communications test set requires additional setup and

preparation. This is described in detail in Appendix F.