User's Manual

Download the BTS68P09258A31–A

Oct 2003

1X SCt 4812T BTS Optimization/ATP

3-39

Download Code and Data to Non–GLI Devices

Downloads to non–GLI devices can be performed individually for each

device or all equipped devices can be downloaded with one action.

NOTE

– When downloading multiple devices, the download may

fail for some of the devices (a time out occurs). These

devices can be downloaded separately after completing the

multiple download.

– CSM devices are RAM code–loaded at the factory. RAM

code is downloaded to CSMs only if updating to a newer

software version.

Follow the procedure in Table 3-14 to download RAM code and data to

non–GLI devices.

Table 3-14: Download RAM Code and Data to Non–GLI Devices

n Step Action

1 Select the target CSM, MCC, and/or BBX device(s) by clicking on

them.

2 Click Device in the BTS menu bar, and select Download >

Code/Data in the pull–down menus.

– A status report displays the result of the download for each

selected device.

3 Click OK to close the status report window when downloading is

completed.

NOTE

After a BBX, CSM or MCC is successfully downloaded with code

and has changed to OOS-RAM, the status LED should be rapidly

flashing GREEN.

NOTE

The command in Step 2 loads both code and data. Data can be

downloaded without doing a code download anytime a device is

OOS–RAM using the command in Step 4.

4 To download just the firmware application data to each device, select

the target device and select: Device>Download>Data

BBX Cards Remain OOS_ROM

If BBX cards remain OOS_ROM (blue) after power–up or following

code load, refer to Table 6-4, steps 9 and 10.