User's Manual

Using the LMF

68P09258A31–A

Oct 2003

1X SCt 4812T BTS Optimization/ATP

3-28

BTS Login from the CLI Environment

Follow the procedure in Table 3-7 to log into a BTS when using the CLI

environment.

NOTE

If the CLI and GUI environments are to be used at the same

time, the GUI must be started first and BTS login must be

performed from the GUI. Refer to Table 3-6 to start the GUI

environment and log into a BTS.

Table 3-7: BTS CLI Login Procedure

n Step Action

1 Double–click the WinLMF CLI desktop icon (if the LMF CLI

environment is not already running).

NOTE

If a BTS was logged into under a GUI session before the CLI

environment was started, the CLI session will be logged into the same

BTS, and Step 2 is not required.

2 At the /wlmf prompt, enter the following command:

where:

host = MGLI card IP address (defaults to address last logged into for

this BTS or 128.0.0.2 if this is first login to this BTS)

port = IP port of the BTS (defaults to port last logged into for this

BTS or 9216 if this is first login to this BTS)

A response similar to the following will be displayed:

LMF>

13:08:18.882 Command Received and Accepted

COMMAND=login bts–33

13:08:18.882 Command In Progress

13:08:21.275 Command Successfully Completed

REASON_CODE=”No Reason”