User Manual

Required Test Equipment and Software – continued

1-18 1X SC4812T–MC BTS Optimization/ATP 5/21/04

DRAFT

Optional Equipment

Not all optional equipment specified here will be supported

by the LMF in automated tests or when executing various

measure type command line interface (CLI) commands. It

is meant to serve as a list of additional equipment that

might be required during maintenance and troubleshooting

operations.

NOTE

Frequency Counter

S Stanford Research Systems SR620 or equivalent. If direct

measurement of the 3 MHz or 19.6608 MHz references is required.

Spectrum Analyzer

S Spectrum Analyzer (HP8594E with CDMA personality card) or

equivalent; required for manual tests.

Local Area Network (LAN) Tester

S Model NETcat 800 LAN troubleshooter (or equivalent); used to

supplement LAN tests using the ohmmeter.

Span Line (T1/E1) Verification Equipment

S As required for local application

Oscilloscope

S Tektronics Model 2445 or equivalent; for waveform viewing, timing,

and measurements or during general troubleshooting procedure.

2–way Splitter

S Mini–Circuits Model ZFSC–2–2500 or equivalent; provides the

diversity receive input to the BTS

High Stability 10 MHz Rubidium Standard

S Stanford Research Systems SR625 or equivalent – required for CSM

and Low Frequency Receiver/High Stability Oscillator (LFR/HSO)

frequency verification.

Itasca Alarms Test Box

S Itasca CGDSCMIS00014 – This test box may be used as a tool to

assist in the testing of customer alarms.