User Manual

Read Me First SCE4812T–MC to SCE4812T Optimization/ATP – continued
1-6 1X SC4812T–MC BTS Optimization/ATP 5/21/04
DRAFT
4–carrier configuration (requires 12 measurements) – Use this
procedure to take measurements with all 4 carriers enabled. The sector
with 2 carriers active will not be measured.
Sector Carrier 1 Carrier 2 Carrier 3 Carrier 4 Sector Carrier 1 Carrier 2 Carrier 3 Carrier 4
1 BBX-1 1 BBX-4 BBX-10
2 BBX-8 2 BBX-2
3 BBX-6 BBX-12 3 BBX-9
Procedure:
1. Enable BBX-1, BBX-8, BBX-6, and BBX-12.
2. Measure TX power from at sector 1 carrier 1
(C1-S1) and sector 2 carrier 2 (C2-S2).
3. Disable BBX-1, BBX-8, BBX-6, and BBX-12.
4. Enable BBX-2, BBX-9, BBX-4, and BBX-10.
5. Measure TX power of C1-S2 and C2-S3.
6. Disable BBX-2, BBX-9, BBX-4, and BBX-10.
Sector Carrier 1 Carrier 2 Carrier 3 Carrier 4 Sector Carrier 1 Carrier 2 Carrier 3 Carrier 4
1 BBX-7 1 BBX-1 BBX-7
2 BBX-5 BBX-11 2 BBX-5
3 BBX-3 3 BBX-12
Procedure:
7. Enable BBX-3, BBX-7, BBX-5, and BBX-11.
8. Measure TX power of C1-S3 and C2-S1.
9. Disable BBX-3, BBX-7, BBX-5, and BBX-11.
10.Enable BBX-1, BBX-7, BBX-5, and BBX-12.
11.Measure TX power of C3-S2 and C4-S3.
12.Disable BBX-1, BBX-7, BBX-5, and BBX-12.
Sector Carrier 1 Carrier 2 Carrier 3 Carrier 4 Sector Carrier 1 Carrier 2 Carrier 3 Carrier 4
1 BBX-10 1 BBX-4
2 BBX-2 BBX-8 2 BBX-11
3 BBX-6 3 BBX-3 BBX-9
Procedure:
13.Enable BBX-2, BBX-8, BBX-6, and BBX-10.
14.Measure TX power of C3-S3 and C4-S1.
15.Disable BBX-2, BBX-8, BBX-6, and BBX-10.
16.Enable BBX-3, BBX-9, BBX-4, and BBX-11.
17.Measure TX power C3-S1 and C4-S2.
18.Disable BBX
-3, BBX-9, BBX-4, and BBX-11.