User Manual

Overview – continued

2-2 1X SC4812T–MC BTS Optimization/ATP 5/21/04

DRAFT

Initial Installation of

Boards/Modules

Follow the procedure in Table 2-1 to verify the initial installation of

boards/modules.

Table 2-1: Initial Installation of Boards/Modules

Step Action

1 Refer to the site documentation and install all boards and modules into the appropriate shelves as

required. Verify they are NOT SEATED at this time.

NOTE

The Switch Card has a configuration switch that must match the site configuration (see Figure 2-1).

2 As the actual site hardware is installed, record the serial number of each module on a “Serial Number

Checklist” in the site logbook.

Configuration Switch in Figure 2-1 shown for 3 Sector

Multicarrier BTS. (Switches 1 and 4 control configuration)

For Multicarrier, switch 1 should be Down; switch 4

depends on whether the frame supports 3 or 6 sector.

NOTE