User Manual

Test Equipment Set Up – continued

5/21/04 1X SC4812T–MC BTS Optimization/ATP 3-51

DRAFT

IS–95 A/B Testing

Optimization and ATP testing for IS–95A/B may be performed using

one of the following test sets:

S CyberTest

S Hewlett–Packard HP 8935

S Hewlett–Packard HP 8921 and HP 437B or Gigatronics Power Meter

S Advantest R3465 and HP 437B or Gigatronics Power Meter

The equipment listed above cannot be used for CDMA 2000 testing.

CDMA 2000 Testing

IS–95 C is the same as CDMA 2000.

NOTE

Optimization and ATP testing for IS–95A/B and CDMA2000 1X sites or

carriers may be performed using the following test equipment:

S Advantest R3267 Analyzer with Advantest R3562 Signal Generator

S Agilent E4406A with E4432B Signal Generator

S Agilent 8935 series E6380A communications test set (formerly HP

8935) with option 200 or R2K and with E4432B signal generator for

1X FER

S Agilent E7495A communications test set

The E4406A/E4432B pair, or the R3267/R3562 pair, should be

connected together using a GPIB cable. In addition, the R3562 and

R3267 should be connected with a serial cable from the Serial I/O to the

Serial I/O. This test equipment is capable of performing tests in both

IS–95 A/B mode and CDMA 2000 mode if the required options are

installed.

Optional test equipment

S Spectrum Analyzer (HP8594E) – can be used to perform cable

calibration.

Test Equipment Preparation

See Appendix F for specific steps to prepare each type of test set and

power meter to perform calibration and ATP.

The Agilent E7495A communications test set requires additional setup

and preparation. This is described in detail in Appendix F.

Test Equipment Connection

Charts

To use the following charts to identify necessary test equipment

connections, locate the communications system analyzer being used in

the COMMUNICATIONS SYSTEM ANALYZER columns, and read

down the column. Where a dot appears in the column, connect one end

of the test cable to that connector. Follow the horizontal line to locate the

end connection(s), reading up the column to identify the appropriate

equipment and/or BTS connector.