User Manual

Entering or Changing BTS Router FE Interface IP Addresses – continued

I-74 1X SC4812T–MC BTS Optimization/ATP 5/21/04

DRAFT

Table I-12: Entering or Changing BTS Router FE Interface IP Addresses and Operating Parameters

Step Action

11 Return to the global configuration mode by entering the following:

exit

A response similar to the following will be displayed:

BTSRTR–bts#–1–1(config–if)# exit

BTSRTR–bts#–1–1(config)#

12 If the IP address and/or parameters for the other FE interface on the router must be assigned or

changed at this time, repeat steps 8 through 11 for the other FE interface.

Once the correct parameters have been set for all FE interfaces, return to the privileged EXEC mode

prompt by holding down the Ctrl key and pressing z (

Ctrl +z).

A response similar to the following will be displayed:

BTSRTR–bts#–1–1(config–if)# ^z

01:11:27: %SYS–5–CONFIG_I: Configured from console by console

BTSRTR–bts#–1–1#

NOTE

Entering exit twice, pressing the Enter key after each entry, will also complete the interface

configuration and return the router to the privileged EXEC mode.

14 Save the interface configuration changes to the startup configuration file on the CF memory card by

entering the following:

copy running–config startup–config

A response similar to the following will be displayed:

BTSRTR–bts#–1–1# copy run start

BTSRTR–bts#–1–1# Destination filename [startup–config]?

15 Press Enter

A response similar to the following will be displayed:

BTSRTR–bts#–1–1# copy run start

BTSRTR–bts#–1–1# Destination filename [startup–config]?

Building configuration...

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!![OK]

BTSRTR–bts#–1–1#

. . . continued on next page