User Manual

Recovery from BTS Router Boot to ROMmon – continued
I-68 1X SC4812T–MC BTS Optimization/ATP 5/21/04
DRAFT
Table I-11: Extended Recovery from BTS Router ROMmon Boot
Step Action
6 Enter the following to initialize the router with the IOS on the additional CF memory card:
boot slot0:IOS_filename
Where IOS_filename = the filename of the IOS noted in step 5, above.
A successful IOS re–boot operation will result in display of a response which begins and ends similar
to the following:
rommon 2 > boot slot0:mwr1900–i–mz.122–8.MC2b.bin
program load complete, entry point: 0x80008000, size: 0xb2a0
program load complete, entry point: 0x80008000, size: 0x6b99ac
Self decompressing the image :
################################################################### [OK]
Smart Init is enabled
smart init is sizing iomem
ID MEMORY_REQ TYPE
00031A 0X005F3C00 MWR1900 Mainboard
0X000F3BB0 public buffer pools
0X00211000 public particle pools
TOTAL: 0X008F87B0
.
.
.
––– System Configuration Dialog –––
Would you like to enter the initial configuration dialog? [yes/no]: n
7 If the router prompts with a question to enter the initial dialog as shown in step 6, above, type no and
press the Enter key to obtain the user EXEC mode prompt.
8 If the router prompts with Press RETURN to get started!, press the Enter key to obtain the
user EXEC mode prompt.
. . . continued on next page
I