User Manual

Recovery from BTS Router Boot to ROMmon – continued

I-62 1X SC4812T–MC BTS Optimization/ATP 5/21/04

DRAFT

Table I-10: Simple Recovery from BTS Router ROMmon Boot

Step Action

12c – If the IOS file is the first file, enter the following command to display the contents of the

startup–config file:

show startup–config

A response which begins similar to the following will be displayed:

BTSRTR1#sh start

Using 1589 out of 57336 bytes

version 12.2

service timestamps debug uptime

service timestamps log uptime

no service password–encryption

hostname BTSRTR1

boot system slot0:mwr1900–i–mz.07132002.bin

no logging console

username cisco password 0 cisco

redundancy

mode y–cable

standalone

13 Review the startup–config file listing for a “boot system” line and perform the following:

13a – If the startup–config file does not contain a boot system line, skip to step 14.

13b – If the file listing contains a “boot system” line, examine it for the correct IOS filename.

13c – If the boot system slot0: filename is incorrect, enter the following, using care to type the filename

correctly:

boot system slot0:IOS_filename

Where IOS_filename = the filename of the IOS noted in step 6, above.

13d – Replace the boot system line in the startup–config file with the line entered in step 13c, above, by

entering the following:

copy runing–config startup–config

. . . continued on next page