User Manual

Recovery from BTS Router Boot to ROMmon – continued
I-60 1X SC4812T–MC BTS Optimization/ATP 5/21/04
DRAFT
Table I-10: Simple Recovery from BTS Router ROMmon Boot
Step Action
8 If an IOS file is found, note the IOS filename, and enter the following to begin recovery to an IOS
boot:
boot slot0:IOS_filename
Where IOS_filename = the filename of the IOS noted in step 6, above.
A successful IOS re–boot operation will result in display of a response which begins and ends similar
to the following:
rommon 2 > boot slot0:mwr1900–i–mz.122–8.MC2b.bin
program load complete, entry point: 0x80008000, size: 0xb2a0
program load complete, entry point: 0x80008000, size: 0x6b99ac
Self decompressing the image :
################################################################### [OK]
Smart Init is enabled
smart init is sizing iomem
ID MEMORY_REQ TYPE
00031A 0X005F3C00 MWR1900 Mainboard
0X000F3BB0 public buffer pools
0X00211000 public particle pools
TOTAL: 0X008F87B0
.
...<output omitted>...
.
Press RETURN to get started!
9 If the router successfully reboots with the IOS, skip to step 12.
10 If the router does not reboot with the IOS, perform the following:
10a – Scroll the HyperTerminal display down until the directory display from step 6, above, is visible.
10b – Compare the IOS filename from the directory display with the filename entered when performing
step 8, above.
10c – If the filename was typed incorrectly, repeat step 8, using care to type the filename correctly.
. . . continued on next page
I