User Manual

Verify and Upgrade ROMmon Version – continued

5/21/04 1X SC4812T–MC BTS Optimization/ATP I-55

DRAFT

Table I-9: Verify and Upgrade/Replace Installed ROMmon Version Using a tftp Server

Step Action

24 Press the Enter key to confirm the deletion.

A response similar to the following will be displayed if the default filename is selected:

Delete filename [MWR1900_RM2.srec.122–8r.MC3.bin]?

Delete slot0:MWR1900_RM2.srec.122–8r.MC3.bin? [confirm]

BTSRTR1#

! CAUTION

In this step, do not delete the IOS and canned–config files from the CF memory card. The BTS

router must have these files on the card to properly boot or switch between packet and circuit mode.

If additional unnecessary files, such as a backup of the startup–config file, are also on the CF

memory card, delete them by repeating steps 22 through 24 for each file.

26 If no other BTS router file operations or configuration actions are required, perform the following:

26a – Remove power from the router and disconnect it from the power supply.

26b – Disconnect all cabling from the BTS router.

26c – On the LMF computer, exit the HyperTerminal communications session.

If no additional tftp transfer activities will be performed, change the NIC IP address and subnet mask

back to those for LMF–BTS communication recorded in Table I-4, step 10b.

! CAUTION

If the BTS 10base–2 LAN IP address and subnet mask for the LMF computer’s NIC are not restored,

the LMF can not log into a BTS when attempting to perform a BTS optimization or ATP.