User Manual

Verify IOS Version and Install Canned Configuration – continued

I-32 1X SC4812T–MC BTS Optimization/ATP 5/21/04

DRAFT

Table I-7: Transfer Canned Configuration Files to the BTS Router Using a TFTP Server

Step Action

17 Scroll the HyperTerminal window back to the slot0: directory display obtained in step 13, above.

18 Compare the file size of startup–config to the canned configuration file to verify the copy operation.

File sizes should be the same.

If desired, the contents of the startup–config file may be verified against the file listings at the end of

this appendix for the blue or red canned configuration, as applicable, by entering the following:

show startup–config

NOTE

Pressing the space bar at the MORE prompt will scroll another screen–full of data. Pressing the Enter

key will scroll the screen one line at a time.

20 Verify the router will boot properly on the IOS and revised startup–config files by entering the

following:

reload

A response similar to the following will be displayed:

BTSRTR1#reload

System configuration has been modified. Save? [yes/no]: n

Proceed with reload? [confirm]

21 If prompted to save a modified configuration, enter n for “no,” and press the Enter key.

22 When prompted to proceed with reload, press the Enter key to continue the reload operation.

NOTE

Reloading the router with the revised startup–config file will change router FE port speed to 100. If

the router FE port speed was changed to 10 to communicate with the LMF computer NIC, the

computer may indicate that the FE LAN connection has been lost at this point.

Verify the router reboots without displaying the rommon 1 > prompt or error messages related to port

configurations. If the router boots to the rommon prompt, proceed to the Recovery from BTS Router

Boot to rommon section of this appendix.

24 Using the tagging materials, tag the router to clearly identify the installed configuration (blue

(BTSRTR1) or red (BTSRTR2)).

25 Remove the CF memory from the router following the procedure in Table I-13, mark the installed

configuration (blue or red) on the card label, and install the card in the router following the procedure

in Table I-14.

26 If an additional router must have the canned configuration installed, perform the following:

. . . continued on next page