User Manual

Verify IOS Version and Install Canned Configuration – continued

5/21/04 1X SC4812T–MC BTS Optimization/ATP I-29

DRAFT

Table I-7: Transfer Canned Configuration Files to the BTS Router Using a TFTP Server

Step Action

8 If the IOS filename from the CF memory card returned in step 5 is different than the filename of the

required IOS version loaded in the LMF computer default tftp directory, perform the procedure in

Table I-8 to load the required version, and then return to step 9, below.

! CAUTION

The file sequence on the CF memory card can not be verified with application programs which place

the listed file names in alphabetical order (for example, certain Unix telnet applications, Unix

directory listing commands, and Windows file managers such as Windows Explorer). This portion of

the procedure is intended for use only with applications, such as HyperTerminal, which do not list

directory contents alphabetically.

If the IOS version is correct and there is more than one file loaded on the CF memory card, be sure the

IOS file is the first file listed in the directory content display. If it is not, perform the following:

9a – Backup all files on the CF memory card to the LMF computer default tftp directory by performing

steps 3 through 10 of Table I-8.

9b – Perform steps 25 through 29 of Table I-8, as applicable.

– Type the following to delete a possible boot system line in the startup–config file, pressing the

Enter key after the command and at each prompt to confirm the filename and deletion operation:

del nvram:startup–config

A response similar to the following will be displayed:

BTSRTR1#del nvram:startup–config

Delete filename [startup–config]?

Delete nvram:startup–config? [confirm]

[OK]

BTSRTR1#

NOTE

Be sure to include the colon (:) after nvram when typing the command.

. . . continued on next page