User Manual

Verify IOS Version and Install Canned Configuration – continued

I-26 1X SC4812T–MC BTS Optimization/ATP 5/21/04

DRAFT

This procedure does not cover all aspects of BTS router

operation and programming. Before performing this

procedure, review BTS router initialization, operation, and

programming information and procedures in MWR1900

Wireless Mobile Edge Router Software Configuration

Guide; part number 78–13983–01. Have this publication

available for reference while performing this procedure.

IMPORTANT

Table I-7: Transfer Canned Configuration Files to the BTS Router Using a TFTP Server

Step Action

! CAUTION

If personal firewall and/or intrusion detection software such as Black ICE is running on the LMF computer,

shut it down before performing this procedure. If this is not done, the tftp transfer process will not operate.

1 On the LMF computer, if it has not been done, start the tftp server according to the manufacturer’s

directions (refer to the Setting Up the TFTP Server – Procedure in the Cellular System Administration

– CDMA OnLine Documentation, 68P09259A20).

2 If a HyperTerminal communication session with the BTS router is not running, start one following the

procedure in Table I-2.

3 In the HyperTerminal window, the router must be in the privileged EXEC mode, as indicated by a

number sign at the end of the prompt:

BTSRTR1#

4 Be sure the Ethernet crossover cable is connected between the LMF computer NIC port and the BTS

router FE 0 port (Figure I-4).

. . . continued on next page