User Manual

Verify IOS Version and Install Canned Configuration – continued

5/21/04 1X SC4812T–MC BTS Optimization/ATP I-25

DRAFT

Table I-6: BTS Router Power–up and Initial Ethernet Configuration

Step Action

9 Verify port FE 0 (fa0/0) is configured with the correct IP address by entering the following:

show ip interface brief

A response similar to the following will be displayed:

BTSRTR1#sh ip int br

Interface IP Address OK? Method Status Protocol

FastEthernet0/0 100.100.100.2 YES manual up up

Serial0:0 unassigned YES unset administratively down down

FastEthernet0/1 unassigned YES unset administratively down down

Serial1:0 unassigned YES unset administratively down down

BTSRTR1#

10 The router is now configured for Ethernet communication on FE 0, and the canned configuration file

can be transferred by tftp. Proceed to Table I-7.

Verifying IOS Version and Canned Configuration File TFTP

Transfer to the BTS Router

Prerequisites – The following is required prior to performing this

procedure:

S A copy of the required MWR 1900 or MWR 1941 router IOS version

file is installed in the default tftp directory (transfer the file to the

LMF computer using FTP, internet download, or media such as a Zip

disk; file size is approximately 7–8 MB)

MWR 1941 routers must be loaded with IOS version

mwr1900–i–mz.122–8.MC2d.bin or later. This router

model will not function properly with earlier IOS versions.

IMPORTANT

IOS verification and canned configuration file transfer – Follow the

procedure in Table I-7 to verify the loaded IOS version and transfer the

canned configuration files from the LMF computer to the BTS router CF

memory card.