User Manual

Verify IOS Version and Install Canned Configuration – continued
I-18 1X SC4812T–MC BTS Optimization/ATP 5/21/04
DRAFT
S 1X SC4812T BTS Optimization/ATP; 68P09260A62 original frame
design or 1X SC4812T–CLPA BTS Optimization/ATP; 68P64115A06
for updated design frames
S Cellular System Administration – CDMA OnLine Documentation,
68P09259A20
S MWR1900 Wireless Mobile Edge Router Software Configuration
Guide; part number 78–13983–01
Preparation for Canned Configuration File TFTP Transfer to CF
Memory Card
Preparation for a canned configuration file tftp transfer consists of the
following activities:
1. Determining the speed of the LMF computer NIC (10 or 100 MHz)
2. Setting the LMF computer NIC IP address
3. Creating a directory (folder) on the LMF computer to be used for all
tftp file transfers
4. Installing the tftp server application on the LMF computer, and
setting the tftp server application root directory to the directory
created in 2, above
5. Connecting the LMF computer to the BTS router for both
HyperTerminal (serial) and Ethernet communication
6. BTS router power–up and initial configuration for Ethernet
communication
The following procedures are used to accomplish all of these preparatory
actions.
Set LMF computer NIC TCP/IP address and create the default
TFTP directory – Follow the procedure in Table I-4 to set the NIC IP
address.
If the IP address for the LAN connection on an LMF
computer is being changed to support tftp downloads to a
BTS router, the BTS 10base–2 LAN IP address and subnet
mask for the NIC must be restored before the LMF can log
into a BTS to perform an optimization or ATP.
IMPORTANT
*
There are differences between Windows 2000 and Windows
98 in the menus and screens used for setting or changing a
NIC connection. In the following procedure, items
applicable to:
S Windows 2000 will be identified with Win2000
S Windows 98 will be identified with Win98
NOTE
I