User Manual

Preparing the LMF – continued
5/21/04 1X SC4812T–MC BTS Optimization/ATP 3-9
DRAFT
Table 3-1: LMF Application Program Installation
n ActionStep
1b – If the Setup screen is not displayed, proceed to Step
2.
2 Click on the Start button.
3 Select Run.
4 Enter d:\autorun In the Open box and click OK.
NOTE
If applicable, replace the letter d with the correct
CD ROM drive letter.
Copy BTS and CBSC CDF or
NEC Files to the LMF Computer
Before logging on to a BTS with the LMF computer to execute
optimization/ATP procedures, the correct
bts–#.cdf and cbsc–#.cdf
or NECB*bts#.xml and NECJ*bts#.xml files must be obtained from the
CBSC and put in a bts-# folder in the LMF computer. This requires
creating versions of the CBSC CDF files on a DOS–formatted floppy
diskette and using the diskette to install the CDF or NEC files on the
LMF computer.
NOTE
– If the LMF has ftp capability, the ftp method can be used to
copy the CDF files from the CBSC.
– On Sun OS workstations, the unix2dos command can be
used in place of the cp command (for example,
unix2dos bts–248.cdf bts–248.cdf). This should be done
using a copy of the CBSC CDF file so the original CBSC
CDF file is not changed to DOS format.
NOTE
When copying CDF or NEC files, comply with the following to
prevent BTS login problems with the LMF:
– The numbers used in the
bts–#.cdf and cbsc–#.cdf or
NECB*bts#.xml and NECJ*bts#.xml filenames must
correspond to the locally assigned numbers for each BTS
and its controlling CBSC.
– The generic
cbsc–1.cdf file supplied with the LMF
works with locally numbered circuit BTS CDF files. Using
this file will not provide a valid optimization unless the
generic file is edited to replace default parameters (for
example, channel numbers and corresponding set power
out) with the operational parameters used locally.
The procedure in Table 3-2 lists the steps required to transfer the CDF or
NEC files from the CBSC to the LMF computer. For further
information, refer to the LMF Help function on line documentation.
3