User Manual

Verifying and Setting GPIB Addresses – continued
5/21/04 1X SC4812T–MC BTS Optimization/ATP F-15
DRAFT
Table F-12: Verify and/or Change Gigatronics 8541C Power Meter GPIB Address
Step Action
2 Use the b arrow key to select CONFIG MENU and press ENTER.
3 Use the b arrow key to select GPIB and press ENTER.
The current Mode and GPIB Address are displayed.
4 If the Mode is not set to 8541C, perform the following to change it:
Use the a arrow keys as required to select MODE.
Use the by arrow keys as required to set MODE to 8541C.
5 If the GPIB address is not set to 13, perform the following to change it:
Use the arrow key to select ADDRESS.
Use the by arrow keys as required to set the GPIB address to 13.
6 Press ENTER to return to normal operation.
RS232 GPIB Interface Box
Ensure that the RS232 GPIB interface box dip switches are set as shown
in Figure F-12.
Figure F-12: RS232 GPIB Interface Box
RS232–GPIB
Interface Box
S MODE
DATA FORMAT
BAUD RATE
GPIB ADRS
ON
DIP SWITCH SETTINGS
G MODE
ti-CDMA-WP-00082-v01-ildoc-ftw
F