User Manual

Verifying and Setting GPIB Addresses – continued

F-10 1X SC4812T–MC BTS Optimization/ATP 5/21/04

DRAFT

This procedure assumes that the test equipment is set up

and ready for testing.

NOTE

Table F-7: Verify and/or Change HP8935 GPIB Address

Step Action

NOTE

The HP I/O configuration MUST be set to Talk & Listen, or NO device on the GPIB bus will be

accessible. (Consult test equipment OEM documentation for additional information as required.)

1 To verify that the GPIB addresses are set correctly, press Shift and LOCAL on the HP8935. The

current HP–IB address is displayed at the top of the screen.

NOTE

HP–IB is the same as GPIB.

2 If the current GPIB address is not set to 18, perform the following to change it:

– Press Shift and Inst Config.

– Turn the Cursor Control knob to move the cursor to the HP–IB Adrs field.

– Press the Cursor Control knob to select the field.

– Turn the Cursor Control knob as required to change the address to 18.

– Press the Cursor Control knob to set the address.

S Press Preset to return to normal operation.

Hewlett Packard HP8921A and

HP83236A/B GPIB Address

Follow the procedure in Table F-8 and refer to Figure F-8, to verify and,

if necessary, change the HP8921A HP83236A GPIB addresses.