User Manual

Verifying and Setting GPIB Addresses – continued
5/21/04 1X SC4812T–MC BTS Optimization/ATP F-9
DRAFT
Advantest R3562 Signal
Generator GPIB Address
Set the GP–IB ADDRESS switch on the rear of the Advantest R3562
signal generator to address 1 as shown in Figure F-6.
Figure F-6: Advantest R3562 GPIB Address Switch Setting
123 4567 8
54321
GP–IP ADDRESS
1
0
GPIB Address set to “1”
ti-CDMA-WP-00084-v01-ildoc-ftw
Agilent 8935 Series E6380
(formerly HP 8935) Test Set
GPIB Address
Follow the procedure in Table F-7 and refer to Figure F-7 to verify and,
if necessary, change the HP8935 GPIB address.
Figure F-7: HP8935 Test Set
FW00885
Preset
Cursor Control
Shift
Inst Config
Local
F