User Manual

Verifying and Setting GPIB Addresses – continued
F-8 1X SC4812T–MC BTS Optimization/ATP 5/21/04
DRAFT
Figure F-5: Setting Advantest R3267 GPIB Address
o
n
REMOTE LED
LCL Key
CONFIG Key
Softkey Lable
Display Area
Softkey
Buttons
Keypad BS Key ENTR Key
ti-CDMA-WP-00083-v01-ildoc-ftw
Table F-6: Verify and Change Advantest R3267 GPIB Address
Step Action
1 If the REMOTE LED is lighted, press the LCL key.
– The LED extinguishes.
2 Press the CONFIG key.
– The CONFIG softkey labels will appear in the softkey label display area of the instrument
display.
– The current GPIB address will be displayed below the GPIB Address softkey label.
3 If the current GPIB address is not set to 18, perform the following to change it:
3a Press the GPIB Address softkey. A GPIB Address entry window will open in the instrument display
showing the current GPIB address.
3b
Enter 18 on the keypad in the ENTRY section of the instrument front panel. Characters typed on the
keypad will replace the address displayed in the GPIB Address entry window.
NOTE
To correct an entry, press the BS (backspace) key at the lower right of the keypad to delete one
character at a time.
3c Press the ENTR key to the lower right of the keypad to enter the address.
– The GPIB Address entry window closes.
– The new address is displayed in the bottom portion of the GPIB Address softkey label.
F